Silver 1/2 x 2 3/8 Service Name Bar

Each one starts as a solid metal service bar with engraved text and a clutch pin back, sized to sit above a uniform pocket.

Silver reads neutral against almost any uniform color and is the safest pick when different departments wear different shirts. Engraved metal bar with paint-filled lettering, clutch pin mounted to the reverse.

The clutch back holds tighter than a bar pin on heavy twill, and the engraved text stays legible after repeated industrial laundering.

The printable window on this blank is 2.1 x 0.3 in, which leaves room for a single engraved line. Surname only, or first initial plus surname.

Names are the thing that breaks a layout, not titles. Set the longest name on your list first, then size everything else around it. If it will not fit at the size in the table below, drop to a first name plus last initial before you shrink the type, because a badge nobody can read from four feet away is worse than a shortened name.

Two clutch posts hold a metal bar flat against heavy twill without rotating, which is exactly why uniform programs specify them over bar pins.

Every badge ships assembled with the backing already attached, so nothing gets built on your end.

This option is $15.99 each at low quantity. The same blank runs down to $15.99 once you reach the top quantity break, so a full-staff order lands well under a piecemeal one. Prices include setup and a digital proof.

Reordering the same artwork later costs the same as the first run. We keep the file, so a single replacement badge takes a name and a reply, not a fresh setup.

Service departments, technicians, hospitality uniforms, and any crew whose shirts go through a laundry service.

If you are outfitting more than one department, order this variant for one group and use a different finish for the other. It reads as intentional and it makes badges easier to sort at the end of a shift.